Nopy nope nope nope...!!! OP writes...in the 1st post..... " It is made of aluminium and is approximately 19cm (7.5") long by 8cm (3.2") wide by 13cm (5.1") high. Any ideas??????????? cheers Stephen.." Sometimes ya gotta read the whole thread thru..... make that all the time !!
I used the search function for posts in this thread using the word 'aluminum'. You were the first poster to call it that; none of OP's posts are listed. And that's because he says it's aluminium.
Ya but it's a great story ! Every post or comment is adding to the quandary.... It may be missing a part or two that would point us in the right direction , but barring that.....or fresh eyes that may have good clues..... it's a fun thread !!
i'm going to run this puppy by an engineering firm's guys & gals.....and see if something comes of it !!
I'm certain it says somewhere in this thread, but I'm not seeing it... what is the diameter of the hole?
the size of the hole is not mentioned..... and the guys i'm showing it to ...are older than millennials...
Thanks. For those needing the conversion, that 14mm is just over 1/2". Which is considerably smaller than I was thinking. Hey, guess what? Still no clue.
After 4 years there are enuf new eyes to warrant one of the stranger things shown here , getting a BUMP !!!!! PS... @Bronwen I apologize for being snarky...& coming off as rude to you. It was before I mellowed here..... .. .. .. Pss...if this thread is new to anyone here.....read from the beginning to see what has been said ....... and just maybe ... we can put this one to bed !!!!